Home/ Contact Us/cladding over decking

cladding over decking

Ask an Expert - Exterior timber, decking & cladding - Wood Naturally Q. My intention is to use traditional tongue and groove floorboards for my veranda floor. I also wish to enclose the space under the veranda for further living space. This is why I wish to waterproof the veranda floor. I have thought about using ply or cement sheeting over the joists and painting with a waterproof membrane. If I was to do this, how would I then attach the floor boards without penetrating the waterproof membrane? Would it still be recommended to have an air gap for 

Composite Outdoor Decking Outdoor Cladding On The Deck 7 Sep 2017 Caring for the environment is important to On The Deck, which is why we work with only the best composite outdoor decking brands to give you a variety of options for your deck that are kind to the eye and the environment. Find out more about the composite outdoor decking and cladding brands below and contact us for a quote. MoistureShield composite decking is innovative and a pioneer in the wood plastic composite decking industry, supplying quality composite 

Composite Decking Benefits Over Wood Decking – EnviroBuild So what is composite decking? Composite decking sometimes also referred to as Plastic decking and WPC decking is decking that is usually made out of a composition of wood and plastic, there are also different varieties such as decking made purely out of plastic. This plastic content gives the deck boards a very long lifespan without the need to treat or seal the decking over its life, the decking has on average a 1% water absorption rate. While the wood content allows the decking to 

Exterior Timber, Decking and Cladding WoodSolutions Home » Exterior Timber, decking and cladding. Question: We were looking at cladding part of a house we are currently working on with timber with some sections on a curved face. Please advise. Answer: It is difficult to fit horizontal timber cladding to a curved wall, although by making a series of vertical cuts in the backs of the boards they can be made more flexible. You could discuss this with your carpenter and see whether a couple of trial pieces would achieve the desired result.

Composite Decking, Cladding & Fencing Care – EnviroBuild HYPERION PRODUCT CARE. Hyperion products will provide years of outdoor living pleasure with the proper installation and care. STORAGE. Material should be covered until it is ready to be installed to maintain a clean surface (use non-translucent material if stored outside); All products should be stored flat and level, supported above the ground at every 500mm interval starting at the board ends; Battons used to separate and support any decking material should be spaced no 

Horizontal cladding - existing buildings Timber Decking & Cladding Specification notes: cladding may be fixed to an existing property in one of three ways : 1.1 Fixed to cladding battens that are fastened directly to the outer wall through the vapour barrier and non compressable insulation using special fixings or, more preferably: 1.2 Fixed to cladding battens and counter battens (if used) over secondary battens/studding attached separately to the wall (as in the drawing) or 1.3 Where there is concern about additional loads being attached or the wall is 

Decking balustrade - Timber Decking and Cladding Association For 'low-level' decks up to 600mm from ground level – decking balustrade height should be 900mm. For 'high-level' decks over 600mm high – decking balustrade height should be 1100mm. Bear in mind that when they are used as a safety barrier, they must conform to UK building regulations (the Building Regulations for England and Wales and the Technical Standards for Scotland). The TDCA can provide you with a Technical Bulletin that covers the issue of decking balustrade 

Sansin SDF (for Cladding, Fencing & Decking) - Silva Timber Sansin SDF's specially formulated oils and resins penetrate deep into the wood, providing outstanding weather and UV protection that won't crack, peel or blister. Whilst we hold stock of Sansin natural tones, all other finishes are made to order using our specialist mixing equipment therefore we can not offer standard delivery times on these products. Made to order finishes will be dispatched within 48 hours. As products are custom mixed to order our standard return policy will not 

Grooved vs smooth Timber Decking & Cladding Association TDCA 13 Oct 2016 It's a question we are asked regularly; which are best grooved or smooth deck boards? The answer may be easier to decipher once you understand where the idea for grooved deck boards came from. In the USA, where timber decking extremely popular, the smooth deck board predominates. In Australia, they advocate to use the grooves face down stating that grooves or reeds on a decking board are designed to allow for airflow underneath the boards to stop 

Before Article:diy pvc hand railings for outdoor steps
Next Article:composite decking around built in pools